Beginner's guide

So you're getting into skimboarding

Skimboarding is running down the beach, dropping a thin board onto the last film of a retreating wave and jumping on. You can learn on flat, wet sand with a cheap wooden board, or sprint out to catch shore-breaking waves on a foam or fiberglass one. Here's flatland vs wave boards, sizing by weight, traction, and how to avoid the classic wipeouts.

By Colin B. · Published November 12, 2026 · Last reviewed November 12, 2026

The 60-second version

If you only buy 3 things to start:

  1. Gator Wooden Skimboard, No Wax Needed — The BPS Gator wooden board. A textured deck means no wax, and it's tough enough for learning.
  2. Foam Skimboard 48-Inch — The Wavestorm 48-inch foam board, for when you start running out to catch small waves.
  3. Quick Humps Surf Wax, Cool to Mid Warm, 3 Pack — Sex Wax Quick Humps. Wave boards need wax or a pad, or your feet slide straight off.
Budget total
$65
Typical total
$210
A BPS wooden skimboard is about $65, and it needs no wax. Add a Wavestorm foam wave board and a pack of wax when you're ready to chase shore break and you're near $210.

We earn commission when you buy through links on this page, including Amazon. See our affiliate disclosure. Price tiers and budget totals shown above are editorial estimates; actual prices vary.

At a glance

Our top pick in each category

The fastest path through this guide — each best-starter pick by category. Scroll for the budget and upgrade alternatives.

CategoryTop pickPriceWhere to buy
Flatland wooden boardsBPSGator Wooden Skimboard, No Wax Needed$$ See on Amazon →
Wave boardsWavestormFoam Skimboard 48-Inch$$$ See on Amazon →
Wax and tractionSex WaxQuick Humps Surf Wax, Cool to Mid Warm, 3 Pack$ See on Amazon →
Before you buy anything

A few things worth knowing first

Start with a wooden flatland board. Wood boards are cheap and tough, and they're made for gliding along the wet sand at the water's edge, which is how everyone learns. Foam and fiberglass wave boards are lighter and float better, so they plane out to meet waves, but they cost more and ding when they hit sand.

Size by weight, not height. Most adults between about 120 and 180 pounds ride boards around 41 to 45 inches. Lighter riders and kids ride 35 to 39 inches. A board that's too small sinks under you and stops dead; too big is hard to drop and control.

Pick the right beach. You want a gently sloped beach with a thin sheet of water running up the sand, usually around mid to low tide. Steep beaches with heavy shore break are for experienced riders. Avoid crowded areas, since loose boards fly a long way.

The gear

What you actually need

A skimboard lying on wet sand at the water's edge

Photo by Let's go Together on Unsplash

Flatland wooden boards

Wooden skimboards are made from layered plywood with a glossy finish. They're heavy enough to glide a long way across wet sand and tough enough to survive rocks and shells. Look for a textured or grippy deck, which means no wax, and pick a size that fits your weight. These boards are for flatland skimming at the water's edge, not for riding out to waves.

Gator Wooden Skimboard, No Wax Needed Best starter
BPS

Gator Wooden Skimboard, No Wax Needed

$64.99 as of Nov 12, 2026

Our rating · In Stock

A wooden flatland skimboard with a textured traction finish on the deck, so you don't need wax. It comes in several sizes for kids through adults and is tough enough to survive learning. The most-reviewed wooden skimboard on Amazon. About $65 and up by size. 750+ reviews at 4.6 stars.

What we like

  • Textured deck, no wax needed
  • Sizes for kids and adults
  • Tough plywood construction

What to know

  • Too heavy for riding waves
  • Pick the size carefully
36-Inch Skipper Skimboard, High Gloss Wood Budget pick
iBOARD

36-Inch Skipper Skimboard, High Gloss Wood

$36.99 as of Nov 12, 2026

Our rating · In Stock

A simple glossy wooden skimboard for kids and lighter riders under about 120 pounds. Fine for trying the sport at the beach. Needs a little wax on the deck. About $37. 83 reviews at 4.2 stars.

What we like

  • Cheap way to try skimming
  • Good size for kids and teens

What to know

  • Too small for most adults
  • Needs wax

Wave boards

Wave skimboards are light foam, fiberglass or carbon boards that float and plane quickly, so you can sprint across wet sand, glide out to an incoming wave and ride it back to shore. Foam boards are the forgiving, affordable way in. Fiberglass boards are faster and more responsive, but they ding if you land on sand or rocks. Wave boards need wax or traction pads on the deck.

Foam Skimboard 48-Inch Best starter
Wavestorm

Foam Skimboard 48-Inch

$129.99 as of Nov 12, 2026

Our rating · In Stock

A light, buoyant foam wave board from the brand known for beginner surfboards. It glides farther than wood and floats you out to small shore break, while the foam is more forgiving if it hits you. Sold by Amazon. About $130. 38 reviews at 4.2 stars.

What we like

  • Floats and planes easily
  • Forgiving foam construction
  • Sold by Amazon

What to know

  • Less durable than fiberglass
  • Few reviews so far
Core V2 Skimboard, Made in the USA Specialty pick
Zap

Core V2 Skimboard, Made in the USA

$209.00 as of Nov 12, 2026

Our rating · In Stock

Zap has made skimboards in Laguna Beach since the 1980s, and the Core V2 is its entry-level wave board: light, with a shape that suits learning to ride shore break. A real skim-brand board for less than most fiberglass. About $209. 8 reviews at 4.5 stars.

What we like

  • From a long-running skim brand
  • Made in the USA
  • Light for wave riding

What to know

  • Limited stock and sizes
  • Few reviews on Amazon
New Zealand Gator Black Fiberglass Skimboard with Carry Bag Upgrade pick
BPS

New Zealand Gator Black Fiberglass Skimboard with Carry Bag

$299.99 as of Nov 12, 2026

Our rating · In Stock

A fiberglass wave board that's stiffer and faster than foam, for riders who are already catching waves and want more glide and pop. It comes with a padded carry bag to protect it from dings. About $300. 18 reviews at 4.7 stars.

What we like

  • Fast and responsive
  • Padded bag included

What to know

  • Dings if it hits sand or rocks
  • Wasted while you're learning

Wax and traction

Without grip, your back foot slides off the instant you land. Most wave boards use surf wax rubbed onto the deck in small circles, or EVA foam traction pads stuck where your feet go. Wax comes in temperature grades: use the one that matches your water, or it'll be too soft or too hard. Pads cost more but never need reapplying.

Quick Humps Surf Wax, Cool to Mid Warm, 3 Pack Best starter
Sex Wax

Quick Humps Surf Wax, Cool to Mid Warm, 3 Pack

$12.00 as of Nov 12, 2026

Our rating · In Stock

The classic surf wax, in a grade for cool to mid-warm water. It builds bumpy grip quickly on a skimboard deck. Three bars last a long season. About $12. 270+ reviews at 4.7 stars.

What we like

  • Grips fast
  • Three bars in the pack

What to know

  • Needs reapplying every few sessions
5 Piece EVA Traction Pad Specialty pick
AQUBONA

5 Piece EVA Traction Pad

$26.99 as of Nov 12, 2026

Our rating · In Stock

Stick-on EVA foam pads for the deck, so you get grip without wax. Lay them where your feet land. More comfortable than wax on bare feet and lasts much longer. About $27. 130 reviews at 4.4 stars.

What we like

  • No wax to reapply
  • Comfortable on bare feet

What to know

  • Placement is permanent
Going deeper

Your first five sessions of skimboarding

Skimboarding starts on wet, flat sand and ends, if you get hooked, riding shore break. The first part takes a few sessions. Here's a five-session plan covering the drop, the step-on, longer glides, turns and your first small wave.

A rider standing in shallow water holding a skimboard at sunset
Photo by Bhong Bahala on Unsplash

Skimboarding looks like magic: a rider sprints down the beach, drops a board and glides for what seems like forever. It’s mostly timing. Get the drop and the step right and the rest follows.

Session 1: The drop

Find a gently sloped beach around mid to low tide, where waves run up the sand in a thin sheet. Watch a few waves come and go. You want the moment a wave has retreated and left a film of water about an inch deep.

Hold the board by its tail with one hand, at your side. Jog a few steps alongside the water, bend down, and drop the board flat onto the film of water just in front of you. Don’t throw it; lay it down level so it slides away. Do this twenty times without stepping on. A flat, level drop is the foundation of everything else.

Session 2: Step on

Now follow the board. As it slides away, step on with your front foot in the middle of the board, then bring your back foot onto the tail. Keep your knees bent and your weight centered. Jumping onto the tail is the most common way beginners shoot the board out from under them and land on their backside.

Start slow, with a short jog. Speed comes later.

Session 3: Longer glides

Add speed gradually: a few more steps, a slightly faster jog. The faster you’re moving when you drop, the farther you’ll glide. Keep your eyes up and ahead, not down at the board.

Practice stepping off smoothly at the end of each ride rather than waiting for the board to stop and tip you.

Session 4: Turns

On a long glide, try leaning gently on your heels or toes to carve the board left or right. Look where you want to go and your shoulders will follow. Small turns at first. If you lean too hard, the rail catches and the board stops.

A skimboarder riding through white water at the shore
Photo by Danny Avila on Unsplash

Session 5: Your first small wave

If you’re comfortable with flatland, try riding out to a small incoming wave. This works best on a foam or fiberglass board, which floats. Wait for a small wave to start building, sprint across the wet sand toward it, drop the board and ride straight out, then turn and ride the wave’s push back to shore.

Start with ankle-high waves and stay away from crowds and swimmers. It takes many tries, so don’t be surprised by a lot of wipeouts.

Ready to choose a board? Our skimboarding gear guide covers wood versus wave boards, sizing and traction.

Save your money

What you don't need yet

Beginners get pressured to buy a lot of stuff that doesn't help them play better. Here's what we'd skip on day one.

  • A carbon fiber board — Pro boards cost $400 or more and ding easily. Learn on wood, then step up to foam or fiberglass.
  • A wetsuit — Flatland skimming happens at the water's edge in shorts. Add a shorty only if your water is cold.
  • A board bag for a wooden board — Wood is tough. Rinse it after the beach and store it out of the sun.
  • Wax for a textured wooden board — Boards with a textured or grippy deck already have traction. Wax only makes them sticky with sand.
First week

Your first seven days

A short, real plan to get from gear-on-doorstep to actually playing.

  1. Buy a wooden board sized for your weight, around 41 inches for most adults. · Buy
  2. Check the tide and head to a gently sloped beach around mid to low tide. · Learn
  3. Practice the drop: run beside the water, hold the board at its tail, and drop it flat in front of you as a wave retreats. · Action
  4. Step on with your front foot in the middle of the board, back foot behind it, knees bent. Don't jump on the tail. · Action
  5. Glide as far as you can, then step off. Repeat thirty times before trying anything else. · Action
  6. Learn to fall safely: let the board go, fall onto your side or backside, and never try to stop a fall with straight arms. · Learn
FAQ

Common questions

Is skimboarding hard to learn?

Flatland skimming on wet sand is quick to pick up, usually within a session or two. Riding waves is much harder, because you need speed, timing and balance to meet the wave and come back. Most people spend a season or more on flatland before chasing waves.

What size skimboard should I get?

Size by weight. Kids and riders under about 120 pounds ride 35 to 39 inches. Most adults between 120 and 180 pounds ride around 41 to 45 inches. Heavier riders go larger. Check each brand's size chart.

Wood or foam skimboard?

Wood for learning on flat, wet sand: it's cheap, tough and glides well. Foam or fiberglass for riding waves: they're lighter and float, so they plane out across the water. Many skimmers own one of each.

Is skimboarding dangerous?

Falls are common, and the sand underneath is hard. Wrists, tailbones and ankles take the most hits. Bend your knees, keep your weight centered, step on rather than jumping on the tail, and learn to fall onto your side. Never ride near swimmers.

When is the best time to skimboard?

Around mid to low tide on a gently sloped beach, when waves wash up as a thin sheet of water. A steep beach at high tide with heavy shore break is for experienced riders only.

Going further

Where to next

Authoritative sources

  • United Skimboarding Association — The US skimboarding association: contests, beach access news, and a community of riders and shops.
  • Surfline Surf Reports — Forecasts and tide charts. Skimming is best around mid to low tide on a sloped beach with small shore break.
  • r/skimboarding — Board sizing questions, beach recommendations and clip feedback from riders of every level.